Printronix l7032 参照マニュアル
150
Chapter
2
Command Codes
Symbols, Printing
Purpose
Prints specialized Standard or Expanded sized symbols
previously created using the z
previously created using the z
x commands described on
Mode
Graphics with an Extended Graphics Command selected
Format
(cc) Z
n (cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
Z
The Print Symbol command. Enter uppercase Z.
n
Represents the symbol to print. See Table 19 on
page 146. Enter the number 1 to print the regis-
tered trademark symbol; enter the number 2 to print
the copyright symbol; enter the User Defined num-
ber from 3 through 9 which corresponds to the
alphabetical value (“a” through “g”) you specified
where the standard sized symbol is stored; or,
enter an upper case character from A through F to
select the corresponding Expanded User Defined
Symbol.
page 146. Enter the number 1 to print the regis-
tered trademark symbol; enter the number 2 to print
the copyright symbol; enter the User Defined num-
ber from 3 through 9 which corresponds to the
alphabetical value (“a” through “g”) you specified
where the standard sized symbol is stored; or,
enter an upper case character from A through F to
select the corresponding Expanded User Defined
Symbol.
For example, in the program example shown on
page 147, the symbol was created and stored at “a”
(^za); when the symbol was
page 147, the symbol was created and stored at “a”
(^za); when the symbol was
printed, it was
specified as 3 (^Z3).
(cc)-
Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
configuration immediately followed by - to end the
command sequence.
Comments
The standard alphanumerics command must be input prior to the
Z command. The alphanumeric height and width parameters do
not affect the symbol. Horizontal tabs and justification commands
and parameters affect symbol position.
Z command. The alphanumeric height and width parameters do
not affect the symbol. Horizontal tabs and justification commands
and parameters affect symbol position.