Printronix l7032 参照マニュアル
382
Appendix E
The PTX_SETUP Commands
Commands
Each emulation has modes in which the PTX_SETUP commands could get
missed. For this reason, it is highly recommended that all PTX_SETUP
commands be placed between print jobs, rather than attempting to imbed
them within jobs.
missed. For this reason, it is highly recommended that all PTX_SETUP
commands be placed between print jobs, rather than attempting to imbed
them within jobs.
PTX_SETUP commands have the following format:
(SFCC)PTX_SETUP
Command–Sub Command;Value
PTR_END
Command–Sub Command;Value
PTR_END
For example, if the SFCC assigned to the emulation you are using is the caret
(^, hex 5E), and you wanted to load configuration number 4 and capture all
incoming data to a file named “BIN”, you would use the following command:
(^, hex 5E), and you wanted to load configuration number 4 and capture all
incoming data to a file named “BIN”, you would use the following command:
^PTX_SETUP
CONFIG–LOAD;4 FILE_IO–CAPTURE;BIN
PTR_END
CONFIG–LOAD;4 FILE_IO–CAPTURE;BIN
PTR_END
Table 76 lists all the command, sub-command, and parameter combinations
and gives a brief description of the command.
and gives a brief description of the command.
NOTE: When a file system error occurs, a message will be displayed on the
front panel indicating the error, and the action needed to take to
correct the error.
correct the error.