Printronix l7032 参照マニュアル
42
Chapter
2
Command Codes
Character Height
Purpose
Specifies a new alphanumeric height.
Mode
Graphics with an Extended Graphics Command selected
Format
(cc) H
ht data (cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
H
The Character Height command. Enter H.
ht
Normal Resolution:
Defines the new character height in tenth inches.
Enter a two-digit height value ranging from 01
through 99 to define a character height of 0.1
through 9.9 inches. The decimal point between the
digits is automatically understood by VGL.
Defines the new character height in tenth inches.
Enter a two-digit height value ranging from 01
through 99 to define a character height of 0.1
through 9.9 inches. The decimal point between the
digits is automatically understood by VGL.
High Resolution:
Defines the new character height in hundredth
inches. Enter a three-digit height value ranging
from 001 through 999 to define a character height
of 0.01 inch through 9.99 inches. VGL
automatically understands the decimal point
between the first and second digits. The actual
height of the printed character increases in
increments of seven printer dots. Changing the
Defines the new character height in hundredth
inches. Enter a three-digit height value ranging
from 001 through 999 to define a character height
of 0.01 inch through 9.99 inches. VGL
automatically understands the decimal point
between the first and second digits. The actual
height of the printed character increases in
increments of seven printer dots. Changing the
ht
field by one printer dot, therefore, may not produce
a change in the actual printed character. You must
increase the field by at least seven printer dots in
order to produce an actual change in character
height.
a change in the actual printed character. You must
increase the field by at least seven printer dots in
order to produce an actual change in character
height.
The printable data for the new height is input
following the new height parameter.
following the new height parameter.
data
Identifies the characters to print at the new height.
(cc)-
Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your VGL configuration
immediately followed by - to end the command
sequence.
Enter the SFCC for your VGL configuration
immediately followed by - to end the command
sequence.
Comments The H command specifies a new alphanumerics height
parameter without sending the complete alphanumerics
command sequence again. Only the character height is affected
by this command; character width, justification, rotation, or any
other parameter specifications remain unchanged. The Character
Height command is input as part of the data in one of the
alphanumeric commands.
command sequence again. Only the character height is affected
by this command; character width, justification, rotation, or any
other parameter specifications remain unchanged. The Character
Height command is input as part of the data in one of the
alphanumeric commands.