Printronix l7032 参照マニュアル
Emulation Switch
77
Emulation Switch
NOTE: The Emulation Switch command is not supported on L7032 printers.
Purpose
Switches to a different emulation.
Mode
Graphics with a Standard Graphics Command selected
Format
(cc) IEMUL,
des (cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
IEMUL,
The emulation switch command. Enter IEMUL,.
des
Three letter symbol to represent the emulation to
switch to. Presently, PGL is the only choice
available.
switch to. Presently, PGL is the only choice
available.
(cc)-
Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
configuration immediately followed by - to end the
command sequence.
Comments Once the system is switched to a new emulation, VGL will be
reset as the default. There is no need to exit the graphic mode
separately.
separately.
Font Load
Purpose
Load binary TrueType font (.ttf) or Intellifont (.sf) into RAMDISK
or flash memory.
or flash memory.
Mode
Standard Graphics mode
Format
(cc)ILOAD,
name, size [,DISK] (cc)G data (cc)G(cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
ILOAD,
The font load command. Enter ILOAD,.
name
Specify associated binary TrueType font or
Intellifont data by name. Enter the name of the font,
including its extension. The maximum length of the
name is 8 characters and the maximum length of
the extension is 3 characters. For example,
93952.sf specifies Courier Bold (Intellifont) and
arial.ttf would represent Arial (TrueType). The
name is used by (cc) IFONT,N command.
Intellifont data by name. Enter the name of the font,
including its extension. The maximum length of the
name is 8 characters and the maximum length of
the extension is 3 characters. For example,
93952.sf specifies Courier Bold (Intellifont) and
arial.ttf would represent Arial (TrueType). The
name is used by (cc) IFONT,N command.
size
Enter the size, in bytes, of the binary TrueType font
or Intellifont data.
or Intellifont data.
DISK
Optional parameter to store the binary data in flash
memory. Enter DISK. By default, the binary data is
stored in RAMDISK when DISK is not specified.
memory. Enter DISK. By default, the binary data is
stored in RAMDISK when DISK is not specified.