Printronix l7032 ユーザーズマニュアル
6.2.16 Distorted Image
the
printer.
5.
If the exit rollers are dirty, clean them. If the
exit rollers are worn or damaged, replace them.
6.
e fuser unit for problems by replacing it with a new unit. Follow the instructions in
If replacing the fuser unit does not fix the problem, reinstall the old fuser unit in the printer.
7. If performing the monthly cleaning procedure does not fix the problem, call a service
technician.
1. Make sure that all consumables are installed in the printer.
2. Make sure that all consumables are within their expected lifespan by checking the
information in the maintenance & service log. Replace any consumable that has been in use
longer than its expected lifespan. Follow the instructions in Chapter 4, Replacing
Consumables.
Consumables.
3. Clean the printer. Follow the instructions in 5.5 Weekly Cleaning Procedure and 5.6 Monthly
4. Replace the OPC module by following the instructions in Section 4.8 Replacing the OPC
Note:
Because the OPC module may not be the cause of the problem, cover the OPC
module with an opaque covering (such as a cardboard box, a large sheet of paper,
module with an opaque covering (such as a cardboard box, a large sheet of paper,
or a large cloth) when you remove it from the printer. The covering protects the
OPC module from damage by exposure to light.
OPC module from damage by exposure to light.
If replacing the OPC module does not fix the problem, reinstall the old OPC module in
Inspect the exit rollers for dirt, wear, or damage.
Check th
S
S
121