Printronix l7032 ユーザーズマニュアル

 

 

 

Figure 4-25. Removing the Exit Rollers 

 
11. Grasp the two white tabs and lift the exit rollers up and out of the printer. 

 
12. While the fuser unit is out of the printer, vacuum the paper dust out of the area around the 

fuser unit. 

 
4.11.3 Install the New Fuser Unit and Exit Rollers 
 

1.  Install the new exit rollers by grasping the two white tabs and lowering the exit rollers into the 

printer. See Figure 4-25 above. 

 

2.  Push the two white tabs all the way down. 
 
3.  Install the new fuser unit by grasping its two handles. Lower the fuser unit into the fuser 

drawer and push the fuser unit back until it fits snugly against the back of the drawer. 

 

4.  Grasp the ends of the exit roller paper guide and return it to its original position. The exit 

roller paper guide should click into place. The inside edge of the exit roller paper guide should 
be just beneath the edge of the fuser unit. See Figure 4-26. 

 

Important:  If the exit roller paper guide does not click into place, you will be able to close the 

fuser drawer and operate the printer, but the paper will not feed properly. 

 

74