Printronix L5035 サービスマニュアル
Physical Description
41
Stacker Operation Keys
The power paper stacker contains the following keys for operating
the elevator:
the elevator:
•
AUTO: Sets the elevator in automatic mode. Pressing this
key causes the elevator table to rise until it reaches its
maximum upper position and enables the stacker.
key causes the elevator table to rise until it reaches its
maximum upper position and enables the stacker.
•
STOP: Stops the elevator, and displays the message
“Stacker Not Ready” on the printer control panel. The
STOP key may be used to stop the elevator from lowering
after pressing the DOWN key.
“Stacker Not Ready” on the printer control panel. The
STOP key may be used to stop the elevator from lowering
after pressing the DOWN key.
•
DOWN: Lowers the elevator until it reaches its maximum
lower position, or until the STOP key is pressed.
lower position, or until the STOP key is pressed.
•
HEAVY: ON equals “Heavy Mode” for thicker paper (LED
is lit); OFF equals “Normal Mode” for thinner paper (LED is
not lit). This key is only active in STOP mode and when
there is no paper in the stacker.
is lit); OFF equals “Normal Mode” for thinner paper (LED is
not lit). This key is only active in STOP mode and when
there is no paper in the stacker.
When operating the power stacker in Heavy Mode, the
maximum stack height
maximum stack height
following a cut or page eject
depends on the page length, as shown in the following
table:
table:
Page Length (inches)
Max. Stack Height (inches)
7.0
7.5
7.5
7.2
8.0
7.0
8.5
6.6
9.0
6.4
9.5
6.1
10.0
5.8
10.5
5.5