Printronix L5535 ユーザーズマニュアル
Chapter 2
Setting The Stacker Page Length
44
NOTE: Normal Mode supports up to 28 lb. bond (105 g/m
2
).
Heavy
Mode must be used for media weights greater than 34 lb.
bond (128 g/m
bond (128 g/m
2
). Some media that are 28 lb. bond (105 g/
m
2
) and higher require Heavy Mode for reliable stacking.
Setting The Stacker Page Length
Set the stacker page length to match the actual page length. On the
side of the stacker, locate the adjustment knob and the window
containing a measuring gauge (a pointer with a scale). Rotate the
knob until the pointer matches the page length being used. (See
page 42.)
side of the stacker, locate the adjustment knob and the window
containing a measuring gauge (a pointer with a scale). Rotate the
knob until the pointer matches the page length being used. (See
page 42.)
Setting The Printer Page Length
NOTE: If the printer page length does not match the stacker page
length, the timing of the stacker swinger arm will be
incorrect, resulting in a folding error.
incorrect, resulting in a folding error.
Set the printer page length by following the instructions for
changing printer configuration. (See the Paper Control menu on
page 96.)
changing printer configuration. (See the Paper Control menu on
page 96.)
Removing Paper
1.
After a print job, press the PAGE EJECT key on the printer
control panel.
control panel.
2.
Tear the paper at the perforation.
3.
Press the DOWN key on the stacker to lower the elevator.
4.
Press the STOP key on the stacker when the elevator is about
half-way down.
half-way down.
11.5
5.0
12.0
4.8
Page Length (Inches)
Max. Stack Height (Inches)