Printronix L5535 ユーザーズマニュアル
Chapter 3
Host Interface Menu
90
IEEE 1284 Parallel Parameters
The IEEE 1284 interface is faster and more versatile than that of
the Centronics interface and supports bidirectional communication.
Configuration of this interface is controlled from the host.
the Centronics interface and supports bidirectional communication.
Configuration of this interface is controlled from the host.
Prime Signal
•
Enable. This parallel port will perform a warm start (reboot)
when the host asserts the Prime Signal.
when the host asserts the Prime Signal.
•
Disable. This parallel port will not perform a warm start (reboot)
if the host asserts the Prime Signal.
if the host asserts the Prime Signal.
TOF Action
•
Reset. A form feed is done before a warm start when the Prime
Signal is asserted from the host. This setting is used only if the
Prime Signal parameter is enabled.
Signal is asserted from the host. This setting is used only if the
Prime Signal parameter is enabled.
•
Do Nothing. Nothing occurs before a warm start when the
prime signal is asserted from the host.
prime signal is asserted from the host.
Buffer Size In K
This option configures the amount of memory allocated for the
IEEE 1284 parallel port buffer. You can specify between 1 and 128
Kbytes.
IEEE 1284 parallel port buffer. You can specify between 1 and 128
Kbytes.
IEEE 1284
Auto
Switching
Switching
Host Interface
Centronics
Dataproducts
Serial
Prime Signal
Buffer Size
In K
In K
Ethernet
1
TOF Action
Enable*
Disable
Disable
Reset*
Do Nothing
Do Nothing
1
2
4
8
2
4
8
*
= Factory Default
1
= If installed
16
32
64*
128
32
64*
128