Printronix P7000 ユーザーズマニュアル
102
Chapter
4
ACTIVE IGP EMUL
ACTIVE IGP EMUL
This ACTIVE IGP EMUL function allows you to activate the desired emulation.
There are two methods for selecting the desired emulation. The first is by
selecting the emulation directly from the printer menu. The second is by
sending a host command which will switch the emulation automatically (see
the appropriate Programmer's Reference Manual
There are two methods for selecting the desired emulation. The first is by
selecting the emulation directly from the printer menu. The second is by
sending a host command which will switch the emulation automatically (see
the appropriate Programmer's Reference Manual
for details).
When changing from one emulation to the other, the printer will load the
power-up configuration and the new emulation parameters. Any configuration
settings performed before selecting these emulations that are not saved in
NVRAM will be lost.
power-up configuration and the new emulation parameters. Any configuration
settings performed before selecting these emulations that are not saved in
NVRAM will be lost.
IMPORTANT
To configure an IGP emulation, the IGP emulation must be selected in
the ACTIVE IGP EMUL menu. The IGP emulation that is not selected will
not appear in the EMULATION menu (see “Main Menu” on page 59).
the ACTIVE IGP EMUL menu. The IGP emulation that is not selected will
not appear in the EMULATION menu (see “Main Menu” on page 59).
ACTIVE IGP
EMUL
* = Factory Default
IGP/PGL*
IGP/VGL
(not shown if any
below are installed)
IGP/VGL
(not shown if any
below are installed)
ANSI (if installed)
PCL-II (if installed)
LG (if installed)
LP+ (with any above)
PCL-II (if installed)
LG (if installed)
LP+ (with any above)