Printronix SL5000r 参照ガイド
Solving Other Printer Problems
315
RIBBON
Printer advances media, but
the ribbon does not advance.
the ribbon does not advance.
1.
Make sure the ribbon is installed correctly.
2.
A poor ribbon/media combination can cause insufficient
friction between the media and ribbon. Verify that the
correct ribbon and media are being used.
friction between the media and ribbon. Verify that the
correct ribbon and media are being used.
3.
The printhead pressure may not be set high enough. Set
the pressure higher.
the pressure higher.
4.
There may be adhesive on the printhead. Clean the
printhead.
printhead.
5.
Verify that Print Mode in the QUICK SETUP or MEDIA
CONTROL menu is set for Transfer and not Direct
Thermal.
CONTROL menu is set for Transfer and not Direct
Thermal.
Printer cuts (melts) through
the transfer ribbon.
the transfer ribbon.
1.
Verify that Print Intensity is set to the proper level in the
QUICK SETUP or MEDIA CONTROL menu.
QUICK SETUP or MEDIA CONTROL menu.
2.
Verify that Print Mode in the QUICK SETUP or MEDIA
CONTROL menu is set for Transfer and not Direct
Thermal.
CONTROL menu is set for Transfer and not Direct
Thermal.
Printing stops and the
ONLINE status indicator
flashes.
ONLINE status indicator
flashes.
1.
Check that the media sensor is clean and undamaged.
2.
Check that the gap between the bottom of a label and the
top of the next label is at least 0.100 inch. Use only labels
and tag stock approved for this printer.
top of the next label is at least 0.100 inch. Use only labels
and tag stock approved for this printer.
3.
Inspect for a jammed label. Remove the jammed label.
4.
Check that the transfer ribbon and label stock are routed
correctly.
correctly.
Narrow width ribbon breaks
frequently.
frequently.
The Ribbon Width value in the MEDIA CONTROL menu is set
too large, which causes too great a ribbon take-up and ribbon
supply spindle torque. Reduce the Ribbon Width value to
decrease the torque on the ribbon spindles. The Ribbon Width
value should be very close to the Label Width value.
too large, which causes too great a ribbon take-up and ribbon
supply spindle torque. Reduce the Ribbon Width value to
decrease the torque on the ribbon spindles. The Ribbon Width
value should be very close to the Label Width value.
To reduce the torque further, set Ribbon Length (in the MEDIA
CONTROL menu) from Save As Paper to Set In Menu. Then
set a value less than the installed ribbon width.
CONTROL menu) from Save As Paper to Set In Menu. Then
set a value less than the installed ribbon width.
Wide width ribbon does not
take up properly. The ribbon
moves past the platen
assembly.
take up properly. The ribbon
moves past the platen
assembly.
The Ribbon Width value in the MEDIA CONTROL menu is set
too narrow for the ribbon installed. Set the Ribbon Width value
to match the width of the ribbon installed. This will increase the
torque on the ribbon take-up spindle.
too narrow for the ribbon installed. Set the Ribbon Width value
to match the width of the ribbon installed. This will increase the
torque on the ribbon take-up spindle.
Table 16. Printer Problems and Solutions (continued)
Symptom
Solution/Explanation