Printronix SL5000r 参照ガイド
Label Peel-Off
61
IMPORTANT
If you do not complete the following step, it will be difficult to remove
the liner from the rewinder.
the liner from the rewinder.
6.
Turn the release lever on the rewinder counterclockwise and lock it in
place. This forms a raised ridge along the width of the rewinder.
place. This forms a raised ridge along the width of the rewinder.
7.
Insert the leading edge of the media into the closest slot of the rewinder,
and slide the media against the back flange.
and slide the media against the back flange.
8.
Hold the media in the slot and rotate the rewinder one full revolution
counterclockwise until the media is taut.
counterclockwise until the media is taut.
9.
Remove labels from the liner so that behind the tear bar the liner is void of
labels for about 1.5 inches and below the tear bar for about 2 inches.
labels for about 1.5 inches and below the tear bar for about 2 inches.
10. Close the front door.
11. Complete the media routing as shown above.
Back Flange
Raised Ridge
Slot
Rewinder Release
Lever
Lever
Liner