Printronix SL5000 参照マニュアル
114
Chapter
4
Configuring the Serial Matrix Emulation with Control Codes
Superscript/Subscript Printing Reset
ASCII Code ESC T
Hex Code
1B 54
Dec Code
27 84
Purpose
Resets superscript and subscript printing as set by ESC S.
Super-Set Commands
ASCII Code ESC | } ;
Hex Code
1B 7C 7D 3B
Dec Code
27 124 125 59
Purpose
Control code sequence used to introduce the super-set
commands.
commands.
Comment
Super-set commands affect the ASCII Emulation as a whole
regardless of the printer protocol currently active. The
commands are sent from the host in the data stream to the
printer, and provide the following capabilities:
regardless of the printer protocol currently active. The
commands are sent from the host in the data stream to the
printer, and provide the following capabilities:
•
Select a printer protocol
•
Change the page orientation
•
Define various font attributes, including typeface and
point size
point size
•
Select proportional fonts
See Chapter 7, “Super-Set Programming,” for further information
on the super-set commands.
on the super-set commands.
Underline
ASCII Code ESC –
n
Hex Code
1B 2D
n
Dec Code
27 45
n
Purpose
Enables or disables automatic underlining of all characters.
where:
n = 0 to disable automatic underlining (hex 00 or hex 30)
n = 1 to enable automatic underlining (hex 01 or hex 31)
n = 1 to enable automatic underlining (hex 01 or hex 31)
Comment
When automatic underline is enabled, all characters, including
spaces, are underlined until disabled.
spaces, are underlined until disabled.
Example
The following sample illustrates automatic underlining and
underlining reset.
underlining reset.