Printronix SL5000 参照マニュアル
198
Chapter
6
Configuring the Epson FX-1050 Emulation with Control Codes
Set Forms Length in Inches
ASCII Code ESC C NUL
n
Hex Code
1B 43 00
n
Dec Code
27 67 0
n
Purpose
Sets the form length to
n inches.
where:
n = 1 through 24 (hex 01 through hex 18) to specify the number
of inches on a form.
of inches on a form.
Comment
Upon receipt of this code, the current line becomes the first line
of the form, and the form length set becomes the current forms
length. Vertical tab positions set below the bottom of the form
are ignored. Forms length is defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command.
of the form, and the form length set becomes the current forms
length. Vertical tab positions set below the bottom of the form
are ignored. Forms length is defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command.
Values of
n greater than 24 are ignored.
When forms length is set by an ESC C NUL sequence, the skip-
over perforation set by ESC N is cancelled.
over perforation set by ESC N is cancelled.
This control code overrides forms length set at the operator
panel.
panel.
Set Relative Horizontal Print Position in
n/120 Inch
ASCII Code ESC \
n1 n2
Hex Code
1B 5C
n1 n2
Dec Code
27 92
n1 n2
Purpose
Moves the logical print head to a relative horizontal print
position, using 1/120 inch increments.
position, using 1/120 inch increments.
Comment
Adds (
n1 + 256n2)/120 inches to the horizontal position of the
logical print head. The number sent is two's complement, with
negative numbers moving to the left. The command is ignored if
it would move the logical print head beyond the page margins.
negative numbers moving to the left. The command is ignored if
it would move the logical print head beyond the page margins.