Printronix SL5000 参照マニュアル
To Exit the P-Series Plot Mode
283
To Exit the P-Series Plot Mode
When returning to the print mode from the P-Series Plot Mode, an extra line
feed should be included in the data stream to maintain proper print line
registration relative to the last line of plot graphics. If the extra line feed is not
included, the first character line after the graphics data may be truncated, as
shown in Figure 36.
feed should be included in the data stream to maintain proper print line
registration relative to the last line of plot graphics. If the extra line feed is not
included, the first character line after the graphics data may be truncated, as
shown in Figure 36.
Figure 36. Truncated Character Line
Combining Graphics and Text
The ASCII Emulation is capable of combining graphics and characters (text)
on the same page in two ways:
on the same page in two ways:
•
Use Bit Image graphics or P-Series Plot mode to produce characters as
well as graphics.
well as graphics.
•
A combination of text (not plot) and graphics can be mixed on the same
page within all protocols.
page within all protocols.
Text and graphics can be mixed on the same line; however, only by using the
Bit Image graphics in the Epson, Serial Matrix or Proprinter XL protocols.
Bit Image graphics in the Epson, Serial Matrix or Proprinter XL protocols.
Any character or symbol can be created in the Plot mode or with Bit Image
graphics simply by addressing and plotting the appropriate dot positions.
graphics simply by addressing and plotting the appropriate dot positions.
Either Bit Image or Plot mode graphics can be mixed with text within the page
on a line by line basis. Each line of graphics data must include a graphics
control code or the emulation automatically defaults to the print mode. Using
Bit Image graphics, it is possible to use the print mode to produce text on one
print pass followed by a print pass to produce graphics on the same line;
however, text characters can be affected by the Bit Image data when
combined on the same line.
on a line by line basis. Each line of graphics data must include a graphics
control code or the emulation automatically defaults to the print mode. Using
Bit Image graphics, it is possible to use the print mode to produce text on one
print pass followed by a print pass to produce graphics on the same line;
however, text characters can be affected by the Bit Image data when
combined on the same line.
@ABCDEFGHIJKLMNOPQR
plot data
plot data
A text line follows plot data,
preceded by a single line
terminator code. (Text characters
may extend into the range of the
previously printed plot line and
appear truncated.)
preceded by a single line
terminator code. (Text characters
may extend into the range of the
previously printed plot line and
appear truncated.)
A text line follows plot data, but is
preceded by an additional line
terminator or LF code. (Characters
are printed at full height.)
preceded by an additional line
terminator or LF code. (Characters
are printed at full height.)
@ABCDEFGHIJKLMNOPQR