Equator ez1710 v オーナーマニュアル

 

 

 

14 

Combo Washer- Dryer Owner’s Manual 

 

 

 

1.  Make sure Washer-Dryer is turned off. (Indicator light should be off). 

2.  Separate clothes into cottons, permanent press and delicates. 

3.  Load clothes of the selected type loosely into the drum. If you are only washing clothes, you can 

fill the drum.  However, if you are washing and then drying, please don’t load clothes more than 
2/3 full. 

4.  Close the Washer-Dryer door.  You will hear a click when it is correctly closed. 

5.  Add detergent to the center compartment of the dispenser (2).  Use low -sudsing detergent  –  

about 1 tablespoon.   If desired, you can add pre-wash detergent, fabric softener and bleach as 
shown in the diagram (see C on page 13). 

6.  Choose a Wash program by turning the washer knob clockwise to the desired setting on the 

control panel.  (See chart on page 15). 

7.  Turn the Dryer knob to the desired amount of minutes for drying.  The left side is for high heat 

and the right side is for less heat. 

8.  If you have a light load or ½ load of clothes, press the ½ load button. 

9.  For delicates only (wool, silk, etc.) if you do not want the drum to spin, press the no spin button.  

Keep in mind that the clothes will retain a fair amount of water. 

10.  Review these steps and check all the settings on the control panel before starting the machine. 

11.  Press the Power button.  The indicator light will come on and in a few seconds, you will hear the 

cycle begin.  

12.  When the Washer-Dryer has completed the cycle, the machine will stop automatically, although 

the indicator light will remain on until you manually press out the Power button. 

 
Note: The door switch of the Washer -Dryer is electronic and locks automatically during the Wash 
cycle. You must wait for 2 minutes after the Wash cycle has stopped to open the door.  Please do 
not try to force the door open. Breaking of the door handle is not covered by warrant y. 
 
You can open the door any time during the Dry cycle without waiting. 
 

Starting your washer-dryer in the right way is important for the quality of your wash, to help prevent 
future problems and enhance life expectancy of your appliance. Once you have loaded your 
washer-dryer and added the detergent together with any fabric conditioner, always check that: 
1) The door is closed correctly. 2) The plug is secured in the socket. 3) The water supply is turned on. 
 
Choose the desired program 
The program is selected according to the type of garments that need to be washed. To choose a 
program, refer to the table on page 15, then:  

1) turn Washer knob until the selected program is aligned with the mark on the knob,   
2) turn Dryer knob to the desired position, 
3) if necessary use buttons ½ LOAD and NO SPIN 
4) lastly, press the Power button. 

 
At the end of the wash cycle... 
Turn the washer-dryer off by pressing Power  button. You can now open the washer-dryer door safely. 
After having removed the freshly cleaned laundry, leave the door open to allow air circulation inside 
the drum. Remember that, in the event of a power failure, or should the washer-dryer switch itself off, 
the program chosen will remain in memory .