Equator ez1710 v オーナーマニュアル

 

 

 

7 

Combo Washer- Dryer Owner’s Manual 

 

 

The model number of this product may be found on 
the back of the unit; the serial number of the label 
affixed to the back of the unit. 

You should note the model and serial numbers of 
this unit in the space provided. Retain this booklet 
as a permanent record of your purchase to aid in 
identification in the event of theft. 

MODEL#   

 

 

 

 

 

 

 

SERIAL#   

 

 

 

 

 

 

 

 
 

 

Your new appliance is carefully engineered product. Many times what appears to be a reason to call 
service, the problem may require nothing more than a simple adjustment you can easily make in your 
own home. 
 
You will be charged for a service call while the appliance is in warranty if the problem is not 
caused by defective product workmanship or materials covered by this warranty. 
 
To avoid a charge for an unnecessary service call, and before calling a serviceman, please refer to 
the troubleshooting section for situations that you can remedy. This section is included on pages 21 of 
this Owner’s Manual. 
Your Washer-Dryer is front loading, with an extra large door openin g for easier access.  It has 8 wash 
cycles. 
 
You will obviously want to obtain the best possible wash. By reading and following the instructions in 
this booklet you will achieve excellent results. 
 
Please, ensure that the instructions are followed. If you should need any further advice or assistance, 
please, contact the dealer where your machine was purchased, or call Equator Customer Service at 
1-800-776-3538 .

 

 

This appliance is an automatic washer-dryer with a capacity of up to: 

6.5 Lbs   dry weight of clothes 

 

1. The unit must be installed on a strong level floor, and in protected, dry, and well-ventilated area 
close to a power and water supply of sufficient capacity, and a sufficient ou tlet. 
2. Installation on Carpet or Wood increases vibrations. 

• Carpets - place on light carpet only.  
• Wood - brace floor with screws and place additional sheets of plywood before installation. 

3. This unit’s installation and grounding should be done in accordance with local codes by a qualified 
installer. “Installation Instructions” are included in this manual for the Installer’s reference. 
4. The unit should be plugged into a properly grounded three (3) prong electrical outlet of 110 V/60Hz 
with minimum 15 Amps, It should not be controlled by a wall switch or pull cord which might be turned 
off accidentally.