Escient taurus ユーザーガイド
FIREABALL REMOTE CONTROL GUIDE WD046-1-2
4/30/2007
APPENDIX B – Detailed Remote Instructions
Nomenclature:
<<Code Set>> means to press and hold the Code Set button on the remote until the LED
flashes twice.
Mode is any of the eight source buttons on the remote.
ID Code Setup
The five digit code obtained from the Appendix A can be programmed as follows:
Mode
Æ <<Code Set>> Æ DigitÆ DigitÆ DigitÆ DigitÆ Digit
When successful, the LED will blink two times after <<Code Set>>. The LED will blink once
after each digit entry except for the last digit and will blink two times to confirm that a valid
code has been programmed. The remote will turn off the LED, automatically exit the
programming mode, return to the idle mode and restore the last preprogrammed codes under
two conditions:
1. When 10 seconds has elapsed after the last key press.
2. When an invalid code is entered upon which the LED will display one long blink.
2. When an invalid code is entered upon which the LED will display one long blink.
The programming mode will be exited at any time by pressing any key other than the digit key.
ID Code Verification (990)
The device code for a mode will be verified as follows:
Mode
ID Code Verification (990)
The device code for a mode will be verified as follows:
Mode
Æ <<Code Set>> Æ 9 Æ 9 Æ 0 Æ 1 (count blinks)Æ 2 (count blinks) Æ 3 (count blinks)
Æ 4 (count blinks).
The number of blinks counted after pressing each digit 1, 2, 3 and 4 key represents the 4 digit
device code for the selected mode beginning with the left most digit. The remote will exit the
Code Verification state when, after performing the sequence <9>
The number of blinks counted after pressing each digit 1, 2, 3 and 4 key represents the 4 digit
device code for the selected mode beginning with the left most digit. The remote will exit the
Code Verification state when, after performing the sequence <9>
Æ <9> Æ <0>, the user
presses any key other than digit 1. If the sequence of pressing digits 1, 2, 3 and 4 for counting
blinks is not maintained, the remote will exit Code Verification state. Operation error and state
exit will be marked by the LED emitting a long blink. The remote will time out after 10 seconds
during programming if no keys are pressed.
blinks is not maintained, the remote will exit Code Verification state. Operation error and state
exit will be marked by the LED emitting a long blink. The remote will time out after 10 seconds
during programming if no keys are pressed.
Example:
To verify the TV code is 0047:
<TV>
<TV>
Æ<<Code Set>> Æ 9 Æ 9 Æ 0 Æ
<1>
Æ 0 blinks
<2>
Æ 0 blinks
<3>
Æ 4 blinks
6640 Intech Blvd. Suite 250 Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com