Toshiba d-kr4 ユーザーズマニュアル
123
Recording
Playback
Others
Introduction
Editing
Function setup
Remote control
The remote control does not work.
• The batteries in the remote control are exhausted.
• The batteries in the remote control are exhausted.
→ Replace all the batteries in the remote control
(
page 18, “INSTALLATION GUIDE”).
• The light emitter of the remote control is not pointed
at the receptor of this recorder.
→ Point the emitter of the remote control at the
→ Point the emitter of the remote control at the
receptor of this recorder.
• The receptor of this recorder is located too far away
from the remote control.
→ Operate the remote control within 7 meters (23 ft)
→ Operate the remote control within 7 meters (23 ft)
from the receptor of this recorder.
• There are obstacles between the remote control and
this recorder.
→ Remove any obstacles.
→ Remove any obstacles.
• The receptor is disturbed by sunlight or fluorescent
light.
→ Change the place of this recorder or shield the
→ Change the place of this recorder or shield the
light.
• The remote mode is not appropriate.
→ Adjust the remote mode of the remote control and
this recorder (
page 44, “INSTALLATION
GUIDE”).
• The setting of the TV/DVD selector is not correct.
→ Set the TV/DVD selector to the equipment to
operate.
Clock
The clock blinks.
→ Complete the initial setting again (
page 30,
“INSTALLATION GUIDE”).
The clock does not keep time.
→ Set the time and date manually (
page 33,
“INSTALLATION GUIDE”).
→ Set “Summer time” or “Time zone” correctly
(
page 34, “INSTALLATION GUIDE”).
Recording
Data cannot be recorded on a DVD-RAM disc.
• The disc is protected from deleting data.
• The disc is protected from deleting data.
→ Set the write-protect tab to the opposite of
“PROTECT” (
page 8).
• The disc is protected by a PC or the recorder.
→ Disable the protection on the device which
protected the disc.
• The disc space is not sufficient.
→ Delete unwanted data (
page 47) or prepare a
new disc.
• The disc is not initialized.
→ Initialize the disc (
page 28).
• The disc may contain errors.
→ Complete the physical format on the disc
(
page 29).
• The physical format on the disc is not completed.
→ Complete the physical format on the disc
(
page 29).
Program
Timer programming cannot be completed.
• Clock setting has not been completed.
• Clock setting has not been completed.
→ Complete the clock setting (
page 33,
“INSTALLATION GUIDE”).
• The programs list is full.
→ Cancel unwanted programs (
page 44).
• When the power goes down, timer programs will be
deleted.
→ Check the timer programs and set them again.
→ Check the timer programs and set them again.