Toshiba rs-tx20 ユーザーガイド

C h a p t e r   9

Detection off, as well. When ‘Phone Avail.’ Detection is off, you may hear a click on the line when the DMS tries to call. This is 
the sound of the DMS picking up the line to see if it is free.

• If you use a wireless modem jack, try connecting the DMS directly to a standard wall jack. 

• If you have a caller ID box, try removing it from the line, since some models interfere with the DMS’s ability to make a call.

• If you have DSL, try installing a DSL filter on your phone line.

• It could be that you have too much line noise due to the length of the phone cord. Try a shorter cord, or you can buy a line noise 

filter at your local electronics store. 

• You can interrupt the connection. To do this, pick up the phone, then hang it up. Wait about 45 seconds. When you pick it up again, 

there should be a dial tone. Repeat this process if necessary. 

• The DMS will continue to attempt to connect several times a day until it is successful. You can check the status of the connection on 

the Phone & Network Setup screen (from TiVo Central, select Messages & Setup, then Settings, then Phone & Network Setup). The 
status of the most recent connection is displayed near the top of the screen.

• TiVo uses either a standard phone line or a broadband Internet connection to provide the TiVo service, and is available as a local call 

in most areas. In some areas, however, local and long distance toll charges may apply. You are responsible for any phone charges.

• You must complete Guided Setup (see Chapter 2) before the DMS can play DVDs or CDs.

• Check that the disc is loaded properly (aligned in the disc tray with the label side up). See page 34 for an illustration of proper 

alignment.