Toshiba rs-tx20 ユーザーガイド
137
Q u e s t i o n s A b o u t C h a n n e l s
9
• You may consider optimizing the IR Control connection as described on page 9.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then Cable/Satellite Box, then Control Cable Setup.
Verify the IR code you chose during Guided Setup. See page 6 for more on choosing an IR code.
• Try using the cable or satellite box’s remote to change the channel. If it doesn’t work, contact the manufacturer or service provider.
If you have a Motorola/General Instruments DCT2000 series cable box or a DIRECTV
®
satellite box and used the Serial Control
cable:
• Make sure the cable or satellite box is turned on.
• Verify that the Serial Control cable is plugged into the data connector on the cable or satellite box and into the Control Out-Serial
jack on the back of the DMS.
• Unplug the cable or satellite box’s power cord, then plug it back in. Then try changing channels with the TiVo remote again.
• Try using the cable or satellite box’s remote to change the channel. If it doesn’t work, contact the manufacturer or service provider.
• Serial control of a Motorola/General Instruments DCT2000 series cable box may not be available for all customers. Check with your
cable provider to find out if your cable box is enabled for serial control.
• Satellite Box Only: You may have incorrectly specified the type of program guide for your DIRECTV satellite box. There are two
types of program guides: MPG (Master Program Guide) and APG (Advanced Program Guide).
To change this option:
First, unplug the power cord for the satellite box, wait a few seconds, then plug it back in. Next, go to TiVo
Central, then Message & Setup, then Settings, the TiVo DMS Setup, then Cable/Satellite Box, then Satellite Channel Changing and
select “Satellite Box.” On the Connection to Satellite screen, if you originally selected Serial-MPG, change your selection to Serial-
APG. (If you originally selected Serial-APG, change it to Serial-MPG.) You can also check the manual for your satellite box (as well
as the satellite box’s system setup screen) for information on the type of program guide it uses.
select “Satellite Box.” On the Connection to Satellite screen, if you originally selected Serial-MPG, change your selection to Serial-
APG. (If you originally selected Serial-APG, change it to Serial-MPG.) You can also check the manual for your satellite box (as well
as the satellite box’s system setup screen) for information on the type of program guide it uses.
I can’t go to one of my channels.
• You may be using a channel list that does not include the channel you want. Use the numbers on the remote control to enter the
channel number, then press ENTER. For more information on using a channel list, see page 68.