Toshiba rs-tx20 ユーザーガイド

S e t u p   2 :   C a b l e   o r   S a t e l l i t e   B o x

Make sure the cable from the wall is connected to your cable or satellite box.

Connect a Composite A/V cable from the Audio/Video Output jacks on the cable or 
satellite box to the Audio/Video Input 1 jacks on the back of the DMS.

Connect a Composite A/V cable from the Audio/Video Output jacks on the DMS to 
the Audio/Video Input jacks on your TV.

Connect the phone cord (see page 8). After you complete Guided Setup, you can 
connect your DMS to a home network and use a broadband Internet connection instead 
of a phone line to connect to the TiVo service. See Chapter 8.

Connect a channel changing cable (see the diagrams to the right).

Plug in all power cords and turn on your TV. 

Set your TV to display video from the input jacks you used in step 

. You may have 

to find the correct TV input setting by pressing the Input or TV/Video button on your 
TV’s remote control until you see the Welcome screen. (For more help, see page 131.)

Once you see the Welcome screen, you’re ready to complete Guided Setup. If you need 
help, see Chapter 2.

(See page 5 for help choosing a channel 

changing cable.)

Plug 

one end of the Serial Control 
cable into the Serial/Data 
connector on the cable or 
satellite box. Plug the other 
end into the Control Out-Serial connector (the upper 
mini jack) on the back of the DMS.

 Plug the purple end of the IR Control cable into 

the Control Out-IR connector (the lower mini-jack) 
on the DMS. 

 Locate the IR sensor (see page 6 for 

help). 

 Mount the IR emitters. Place one emitter 

on top of the cable/satellite box and the other 
underneath it. Be sure both emitters stick out about 
1.5 inches directly in front of the IR sensor. Use the 
provided adhesive strips to hold the emitters in place.

®