Toshiba sd-2705 オーナーマニュアル

PAGE 38

Each DVD disc has a variety of audio output
options. Set the player’s Digital Audio Output
according to the type of audio system you use. 

D

D

E

E

G

G

D

D

E

E

You can select Digital Audio Output or Sampling
Frequency item by pressing SELECT/ENTER.

■

Select “DOLBY DIGITAL/PCM” if

an active digital output is supplied to a Dolby Digital decoder,
(or an amplifier or other equipment with Dolby Digital
decoder).

Select “Stream/PCM” if an active 

digital output is supplied to an amplifier or other 
equipment with DTS decoder, Dolby Digital decoder and
MPEG decoder.

Select “PCM” if an active digital output is 

supplied to an amplifier or other equipment with linear PCM
only (or MD recorder or DAT deck).

■

To change the Sample Frequency setting, first select the
desired digital audio output type as indicated above.
If your A/V receiver or surround processor is NOT capable of
handling 96kHz signals, select the 48kHz option. When this
choice is made, this unit will automatically convert any 96kHz
signals to a 48kHz output so that your system is capable of
decoding them. 
If your A/V receiver or surround processor is capable of 
handling 96kHz signals, select the 96kHz option. When this
choice is made, this unit will pass each type of signal through
without any further processing. 

❍

When you are not using the player’s digital audio output, don’t
select any of the options.

❍

If an active digital audio output signal is supplied to a receiver or
other equipment without a corresponding digital decoding capa-
bility, a very loud noise may be produced which could 
permanently damage the speakers.

❍

The DTS DVD disc sound is played back only when the DVD
player is connected to a receiver with a DTS decoder.

PCM

DTS bit Stream

Dolby Digital
bit Stream

MPEG bit Stream

PCM

DTS bit Stream

PCM

DTS bit Stream

Dolby Digital
bit Stream

PCM

PCM

DTS bit Stream

PCM

DTS bit Stream

PCM

PCM

PCM

DTS bit Stream