Toshiba sd-3980 オーナーマニュアル

17

Connections

Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment

from the wall outlet before making any connections.

• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the

DVD video player away from the tuner and radio.

• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate

listening level. Otherwise, high volume sound may damage your hearing as well as the speakers.

• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power

on, the speakers may be damaged.

• Progressive can be on/off only when “Video Output”  is set to Component 

.

• In component connections, the screen might become pinkish in color when the “Video Output” is set to Composite. This is

not a defect of this unit 

.

• When Progressive is on, only component video will be output.
• Analog audio out will not have sound if DTS playback is selected.
• When using component video cables, do not connect the S video cable.

Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,
C

B

, C

R

)

In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.

Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal.  Connecting to these inputs allows
you to view the highest quality pictures with less flicker.

Consumers should note that not all high definition
television sets are fully compatible with this product and
may cause artifacts to be displayed in the picture. In case
of 525 progressive scan picture problems, it is
recommended that the user switch the connection to the
“standard definition” output. If there are questions
regarding our TV set compatibility with this model 525p
DVD player, please contact our Customer Service Center.

• Make the following setting.

On-screen display

Select:

Page

“PCM” or

“Bitstream”

“Digital Output”

Component

“Video Output”

You can temporarily switch the output signal for better picture
quality.
Press PROGRESSIVE on the remote control during stop mode.
Press PROGRESSIVE again to turn off progressive mode.

ColorStream

®

 and ColorStream Pro

®

 are registered trademarks of Toshiba America Consumer Products,  L.L.C.