Jabra JX20 Pura クイック設定ガイド
Eargel
JX20 PURA
JX20 PURA
JX20 PURA
what the lights mean
1a: First time pairing:
Turn headset on - automatically
goes into pairing mode.
Turn headset on - automatically
goes into pairing mode.
2. Activate Bluetooth on you phone.
3. Press ‘Yes’ on the phone and confirm with PIN code 0000 (4 zeros).
4. Typical view in mobile phone.
3. Press ‘Yes’ on the phone and confirm with PIN code 0000 (4 zeros).
4. Typical view in mobile phone.
Pairing the headset with your Phone
using your headset
wearing style
Control volume
Press
volume up
Press
volume down
Answer a call
End call
End call
With earhook
1b: Later pairing:
Turn headset on - Press and hold
the answer / end button until
the LED on the back shines
continuously.
Turn headset on - Press and hold
the answer / end button until
the LED on the back shines
continuously.
Without earhook
On/off switch
(rotate earpiece
90 degrees).
(rotate earpiece
90 degrees).
Place eargel over earpiece
Charge and turn on your headset
When the device is fully
charged all 5 steps of
the LED are lit.
charged all 5 steps of
the LED are lit.
Fig. 1
What you see
What this means about your
headset
headset
Solid light
The headset is in pairing
mode
Quick flash every 5 seconds for
1 minute
Connected and not on active
call (reappears if you have
asked for battery status)
LED flashing for 1 second, then
1½ second pause then repeats
Incoming call
LED flashing twice and then
turning off
Pairing succeeded
LED flashes once then solid white
Pairing failed
LED flashes once
0-25% charged
LED flashes twice
25-50% charged
LED flashes three times
50-75% charged
LED flashes four times
75%-100% charged
LED soild white
Fully charged
attaChing earhook