Netgear fr314 参照ガイド
Reference Guide for the Model FR314, FR318 and FV318 Cable/DSL Firewall and VPN Routers
Setting Up the Hardware
2-5
Connecting to Your Local Ethernet Network
Your local network attaches to the firewall router ports that are marked LOCAL. The LOCAL
ports of the firewall router are capable of operation at either 10 Mbps (10BASE-T) or 100 Mbps
(100BASE-TX), depending on the Ethernet interface of the attached PC, hub, or switch. If any
connection will operate at 100 Mbps, you must use a Category 5 (Cat 5) rated cable, such as the
Ethernet cable included with your firewall router.
ports of the firewall router are capable of operation at either 10 Mbps (10BASE-T) or 100 Mbps
(100BASE-TX), depending on the Ethernet interface of the attached PC, hub, or switch. If any
connection will operate at 100 Mbps, you must use a Category 5 (Cat 5) rated cable, such as the
Ethernet cable included with your firewall router.
The Netgear Firewall/VPN Router incorporates a 4-port (FR314) or 8-port (FR318 and FV318)
switch for connection to your local network.
switch for connection to your local network.
To connect the firewall router to your LAN:
1.
Connect your PCs directly to any of the LOCAL ports of the firewall router using standard
Ethernet cables.
Ethernet cables.
2.
(FR314) Verify that the NORMAL/UPLINK switch of the last LOCAL port is set to
NORMAL.
NORMAL.
If your local network consists of more hosts than LOCAL ports, you need to connect your firewall
router to another hub or switch. For the FR314, this can be done using either of the following
methods:
router to another hub or switch. For the FR314, this can be done using either of the following
methods:
Connect the FR314’s last LOCAL port to any normal port of an Ethernet hub or switch using
standard Ethernet cable. Push in the NORMAL/UPLINK switch of the firewall router to select
UPLINK.
standard Ethernet cable. Push in the NORMAL/UPLINK switch of the firewall router to select
UPLINK.
OR
Connect any LOCAL port of your FR314 to the UPLINK port of an Ethernet hub or switch.
For the FR318 and FV318, connect any LOCAL port of your firewall router to any port of an
Ethernet hub or switch. The LOCAL port will automatically configure itself for the uplink
connection.
Ethernet hub or switch. The LOCAL port will automatically configure itself for the uplink
connection.
Note:
The Netgear Firewall/VPN Router incorporates Auto Uplink
TM
technology. Each LOCAL
Ethernet port will automatically sense whether the Ethernet cable plugged into the port should
have a 'normal' connection (e.g. connecting to a PC) or an 'uplink' connection (e.g. connecting to a
router, switch, or hub). That port will then configure itself to the correct configuration. This feature
also eliminates the need to worry about crossover cables, as Auto Uplink will accommodate either
type of cable to make the right connection.
have a 'normal' connection (e.g. connecting to a PC) or an 'uplink' connection (e.g. connecting to a
router, switch, or hub). That port will then configure itself to the correct configuration. This feature
also eliminates the need to worry about crossover cables, as Auto Uplink will accommodate either
type of cable to make the right connection.