Netgear fr314 参照ガイド
Reference Guide for the Model FR314, FR318 and FV318 Cable/DSL Firewall and VPN Routers
Preparing Your Network
3-5
To check your PC’s TCP/IP configuration:
1.
On the Windows taskbar, click the Start button, and then click Run.
The Run window opens.
2.
Type
winipcfg
, and then click OK.
The IP Configuration window opens, which lists (among other things), your IP address, subnet
mask, and default gateway.
mask, and default gateway.
3.
Select your Ethernet adapter.
The window is updated to show your settings, which should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
using the default TCP/IP settings that NETGEAR recommends:
•
The IP address is between 192.168.0.2 and 192.168.0.9
•
The subnet mask is 255.255.255.0
•
The default gateway is 192.168.0.1
At this point, your PCs can communicate with each other and with the firewall router, but they still
require DNS Server addresses in order to browse the Internet. The DNS Server addresses are not
assigned until after the firewall router is configured and the PCs are rebooted.
require DNS Server addresses in order to browse the Internet. The DNS Server addresses are not
assigned until after the firewall router is configured and the PCs are rebooted.
Configuring the Macintosh for IP Networking
Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On
each networked Macintosh, you will need to configure TCP/IP to use DHCP by following these
steps:
each networked Macintosh, you will need to configure TCP/IP to use DHCP by following these
steps:
1.
From the Apple menu, select Control Panels, then TCP/IP.
Note:
Reboot all attached PCs again after your firewall router is configured, or the PCs
will not be able to browse the Internet. The firewall router cannot assign DNS addresses
to your PCs until after it is configured.
to your PCs until after it is configured.