Netgear FVL328 参照マニュアル
Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual Revision 2
Managing Your Network
7-19
May 2004, 202-10030-02
2.
The firewall will then reboot automatically.
After an erase, the firewall's password will be password, the LAN IP address will be
192.168.0.1, and the router's DHCP client will be enabled.
192.168.0.1, and the router's DHCP client will be enabled.
Note: To restore the factory default configuration settings without knowing the login password
or IP address, you must use the Default Reset button on the rear panel of the firewall. See
or IP address, you must use the Default Reset button on the rear panel of the firewall. See
Running Diagnostic Utilities and Rebooting the Router
The FVL328 Firewall has a diagnostics feature. For normal operation, these functions are not
required.
required.
From the main menu of the browser interface, under the Maintenance heading, select the
Diagnostics link to display the menu shown below. Then select the function you want to activate.
Diagnostics link to display the menu shown below. Then select the function you want to activate.
Figure 7-13: Diagnostics menu
You can use the diagnostics menu to perform the following functions from the firewall:
•
Ping an IP Address to test connectivity to see if you can reach a remote host.
•
Often called Trace Route, this will list all Routers between the source (this device) and the
destination IP address. The Trace Route results will be displayed in a new screen.
destination IP address. The Trace Route results will be displayed in a new screen.