Netgear FVL328 参照マニュアル
NETGEAR VPN Client to NETGEAR FVL328 or FWAG114 VPN Router
G-1
May 2004, 202-10030-02
Appendix G
NETGEAR VPN Client
to NETGEAR FVL328 or FWAG114 VPN Router
Follow these procedures to configure a VPN tunnel from a NETGEAR ProSafe VPN Client to an
FVL328. This case study follows the Virtual Private Network Consortium (VPNC)
interoperability profile guidelines. The configuration options for the FVS328 and FWAG114 are
the same.
FVL328. This case study follows the Virtual Private Network Consortium (VPNC)
interoperability profile guidelines. The configuration options for the FVS328 and FWAG114 are
the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table G-1.
Summary
VPN Consortium Scenario:
Scenario 1
Type of VPN
PC/Client-to-Gateway
Security Scheme:
IKE with Preshared Secret/Key (not Certificate-based)
Date Tested:
December 2003
Model/Firmware Tested:
Gateway
NETGEAR FVL328 firmware v 1.5 or FWAG114 firmware v 2.1
Client
FVL328 Prosafe High Speed VPN Firewall v10.1
IP Addressing:
Gateway Static
IP
address
Client Dynamic