Netgear HR314 参照マニュアル

2-6

Setting Up the Hardware

•

The SSID should be 

 (note the capitalization). 

•

WEP encryption is disabled.

•

Your IP address must be in the range of 192.168.0.3 to 192.168.0.254, with a netmask of 
255.255.255.0

See 

” for full details on setting up wireless connections.

To connect the router to the power adapter:

1.

Plug the connector of the power adapter into the power adapter outlet on the rear panel of the 
router.

2.

Plug the other end of the adapter into a standard wall outlet.

3.

Verify that the Power LED on the router is lit.

After applying power to the router, complete the following steps to verify the connections to it:

1.

When power is first applied, verify that the POWER LED is on.

2.

Verify that the TEST LED turns on within a few seconds.

3.

After approximately 10 seconds, verify that:

a.

The TEST LED has turned off.

b.

The WIRELESS LINK/ACT LED is lit.

c.

The LOCAL LINK/ACT LEDs are lit for any local ports that are connected.

d.

The INTERNET LINK/ACT LED is lit.

If a LINK/ACT LED is lit, a link has been established to the connected device.

4.

If any LOCAL port is connected to a 100 Mbps device, verify that the 100 LED for that port is 
lit.

The router is now properly attached to the network. Next, you need to prepare your network to 
access the Internet through the router. See the following chapter.