Netgear DGND3700 ユーザーガイド

The following figure shows an example of a repeater mode configuration.

Internet

PCs

Wireless PC

 

AP 1 (parent AP in repeater mode)

AP 3 in repeater mode

 

Wireless PC
associated

with AP 3

AP 2 in repeater mode

associated

with AP 2

Wireless PC

with AP 1

associated

DGND3700

192.168.0.1

 



Configure the operating mode of the devices.

Configure AP 1 (the DGND3700 wireless modem router in the preceding figure) with 

the MAC address of AP 2 and AP 3 in the first two Remote MAC Address fields.

Configure AP 2 with the MAC address of AP 1 in the Remote MAC Address field.

Configure AP 3 with the MAC address of AP 1 in the Remote MAC Address field.

Verify the following for both access points:

The LAN network configuration of each access point is configured to operate in the 

same LAN network address range as the LAN devices.

The access points have to be on the same LAN. That is, the LAN IP addresses for the 

access points have to be in the same network.

If you are using DHCP, for all access points, in the Basic Settings screen, in the 

Internet IP Address section, the Get Dynamically from ISP check box should be 
selected.

Access point devices have to use the same SSID, channel, authentication mode, and 
encryption.

Verify connectivity across the LANs. A computer on any LAN segment should be able to 
connect to the Internet or share files and printers with any other PCs or servers connected 
to any of the three WLAN segments.

Remote Management

The Remote Management screen lets you allow a user or users on the Internet to configure, 
upgrade, and check the status of your wireless modem router.