Netgear wgr101 インストールガイド

Use this guide to quickly set up your router. For advanced options, see the latest 
manual at http://kbserver.netgear.com/documentation/WGR101.asp.

These instructions assume the following:

•

You will connect the WGR101 wireless travel router to an RJ45 wall port in an 
office or hotel, or a broadband router at home.

•

Wireless WEP security is disabled.

•

One or more wireless computers will connect to the WGR101 wireless travel 
router. 

Use WEP to protect sensitive data, according to the instructions in the Reference 
Manual on the CD. 

a. Connect an Ethernet cable to the port on the WGR101 wireless travel router. 

If you are traveling, connect the other end of the cable to an RJ45 port in the 
wall. If you are at home or in an office, connect the other end of the cable to 
a switch, router, or cable modem with a broadband Internet connection. 

b. The WGR101 wireless travel router ships with the switch in position 1 for a 

single user. If multiple computers will use the wireless travel router, change 
the switch position to 2.

c. Connect the power cord to the WGR101 and plug it into an outlet. The 

Power LED lights up. The WGR101 automatically broadcasts a wireless 
signal.

d. Check the WGR101 wireless travel router status lights to verify the 

following:

•

Power: The power light should turn solid green. When you first turn on 
the router, the power light blinks during its self test, then turns solid 
green. If it does not, see the Troubleshooting Tips in the manual.

•

Wireless: The wireless light should be lit. If the Wireless light is not lit, 
see the Troubleshooting Tips in the manual.

•

Ethernet: The Ethernet light should only be lit when an Ethernet cable is 
connected to the unit and is also connected to a powered on computer or 
network device at the other end. 

a. On your computer, set NETGEAR-TRAVEL as the SSID for each 

computer that will use the WGR101. 
Tip: If you are typing the SSID, note that it is case sensitive and must match 
the WGR101 SSID exactly. 

b. The wireless LED on the WGR101 is on when wireless communication is 

enabled. This LED flashes during data transfer. 

Here are some tips for correcting simple problems you may have.

The Wireless Network Name (SSID) and WEP security settings of the router and 
wireless computer must match exactly. 

Ethernet cable and wirelessly connected computers must be configured to obtain IP 
and DNS addresses automatically via DHCP. For help with this, please see the 
animated tutorials on the CD or the Reference Manual Appendix C on the CD.

If the Power light does not turn solid green within 2 minutes of turning the router on, 
reset the router as described in the Reference Manual on the CD.

Connecting the WGR101 directly to a DSL modem is not supported.

In single user mode, this is not a problem. In multi-user mode, you need to change 
the WGR101 LAN IP address and DHCP server pool according to the instructions in 
the help screens or Reference Manual. 

)NSTALLATION

3WITCH