Netgear WNR2000 インストール手順

30

Troubleshooting

–

LAN connected computers must be configured to obtain an IP address automatically using 
DHCP. For more information, see the links in 

–

Some cable modem services require you to use the MAC address of the computer 
registered on the account. If so, in the Router MAC Address section of the Basic Settings 
menu, select “Use this Computer’s MAC Address.” Click Apply to save your settings. 
Restart the network in the correct sequence.

•

Check the router status lights to verify correct router operation. If the Power light does 
not turn solid green within 2 minutes after turning the router on, reset the router according to 
the instructions in 

.

After you turn on power to the router, check that the following sequence of events has occurred:

1. When power is first applied, verify that the power light is on (see 

 for 

an illustration).

2. Verify that the power light turns amber within a few seconds, indicating that the self-test 

procedure is running.

3. After approximately 20 seconds, verify that:

a.

The color of the power light changes to green.

b. The LAN port lights are lit for any local ports that are connected.

If a port’s light is lit, a link has been established to the connected device. If a LAN port is 
connected to a 100 Mbps device, verify that the port’s light is green. If the port is 10 Mbps, 
the light will be amber.

c.

The Internet port is connected and its light is lit.

4. If you have enabled WPS security, verify that the push-button stops blinking and changes to 

green (otherwise the push-button light should be off).

If the correct behavior does not occur, check for a remedy from the following list:

•

Power Light Not On. If the Power and other lights are off (see 

), check the following:

–

Make sure that the power cord is properly connected to your router and that the power 
adapter is properly connected to a functioning power outlet.

–

Check that you are using the power adapter supplied by NETGEAR for this product.