Netopia 2e-h-w ユーザーガイド

Cayman 2E-H-W User’s Guide

Using the Command Line Interface

November 2000

You can configure as many as 16 static IP routes for a Cayman 
2E-H-W. Use the following commands to maintain static routes to the 
Cayman 2E-H-W routing table:

set ip static-routes destination-network net_address

Specifies the network address for the static route. Enter a network 
address in the 

 argument in dotted decimal format. The 

 argument cannot be 0.0.0.0.

set ip static-routes destination-network net_address 

netmask netmask

Specifies the subnet mask for the IP network at the other end of the 
static route. Enter the 

 argument in dotted decimal format. 

The subnet mask associated with the destination network must 
represent the same network class (A, B, or C) or a lower class (such 
as a class C subnet mask for class B network number) to be valid.

set ip static-routes destination-network net_address 

interface [ ip-address | ppp ]

Specifies the interface through which the static route is accessible.

set ip static-routes destination-network net_address 

gateway-address gate_address

If you specified the gateway is accessible through an IP address, 
specifies the IP address of the gateway for the static route. The 
default gateway must be located on a network connected to the 
Cayman 2E-H-W configured interface.

set ip static-routes destination-network net_address 

metric integer

Specifies the metric (hop count) for the static route. The default 
metric is 1. Enter a number from 1 to 15 for the integer argument to 
indicate the number of routers (actual or best guess) a packet must 
traverse to reach the remote network.

You can enter a metric of 1 to indicate either: