Mitsubishi WS-55517 ユーザーズマニュアル

The Name screen allows you to change the default 

name for each device to a custom name of up to eight 

characters (including a blank space), selecting from 

letters, numbers and nine different characters.  Press 

ADJUST 

 or 

 to select each letter, then press 

ENTER to move to the next position.  Press CANCEL 
on the remote to delete the current letter and move 
back one character position.  When in the first position, 
the CANCEL button will return the name to the default 
name.

After learning the basic device keys, the [Device] 
Advanced Learn screen allows you to learn any special 

keys for your device.  Most common IR remote control 
signal formats can be learned by NetCommand.  

A table of specialized device keys is shown in Appendix 

E. You only need to learn the functions your devices 
respond to and can ignore the functions that do not 
apply to your device.

1.  Press ADJUST 

 , 

 ,   or   to select the check 

box for each function to be learned.

2.  Press ENTER and the function name will begin to 

flash to confirm the ready-to-learn status.

3.  Press the button on the device’s remote control that 

corresponds to the selected function.  A check mark 
will appear and the function name will stop flashing.  

This confirms the signal learned status.

4.  To test the learned command, press ENTER 

on the TV remote while the learned function is 

highlighted.  The device should perform the selected 
function.  The device needs to be turned on and 
the IR emitters properly placed for the test to be 
successful (see page 22 for IR emitter placement).

5.  Repeat for each function to be learned. 

6.  To erase a learned function, highlight the check box 

for that function and press CANCEL.

7.  When the function signals have been learned, press 

ADJUST    to select Next> and move to the [Device] 
Advanced Learn screen.

NOTE: When learning the device’s remote control 

signals, point the device’s remote control at the 

TV screen.