Champion cg4 ユーザーガイド
CONDITION
CAUSE
SOLUTION
Water temperature low
Thermostat setting low........................Adjust thermostat
in detergent tank
Thermostat defective...........................Replace
Defective float switch .........................Replace
Heater burnt out ..................................Check and replace
Defective float switch .........................Replace
Heater burnt out ..................................Check and replace
Ensure water level is above element
Incoming water temp. low ..................Hot water supply min. 145°F/66°C
Water on floor around
Pump seal leaking ...............................Replace
machine
Rinse drain in wash area plugged .......Clear obstruction, clean machine
Wash return screen in detergent..........Clean
tank plugged
Drain screen under detergent .............Clean
tank plugged
Main drain plugged .............................Clean
Detergent tank covers are not .............Position all top covers to completely cover
positioned properly causing
tank plugged
Drain screen under detergent .............Clean
tank plugged
Main drain plugged .............................Clean
Detergent tank covers are not .............Position all top covers to completely cover
positioned properly causing
top of tank
condensation
Fill chute has lime build-up ................De-scale detergent tank
Spray tube clean out caps loose ..........Tighten caps
or o-rings damaged
Fill chute has lime build-up ................De-scale detergent tank
Spray tube clean out caps loose ..........Tighten caps
or o-rings damaged
Replace o-rings
Chemical containers filling
Dirty rinse tubes ..................................Refer to cleaning section
with water
Element tube worn ..............................Replace
Worn flow washer in solenoid ...........Replace
valve
Worn flow washer in solenoid ...........Replace
valve
Chemicals not feeding
No product in containers .....................Refill container
Product gelling or crystallizing ...........Flush all lines with hot water and use fresh
in chemical line
Product gelling or crystallizing ...........Flush all lines with hot water and use fresh
in chemical line
supply of chemical
Chemical supply strainer plugged.......Clean with hot water
Speed adjustment set too low..............Increase by turning clockwise while machine
Speed adjustment set too low..............Increase by turning clockwise while machine
is running/filling
No power to pump ..............................Check power LED on chemical control board
Check signal LED for detergent, sanitize/rinse
on board
Replace board if necessary
on board
Replace board if necessary
Pump motor defective .........................Replace pump motor
Element tube stretched ........................Replace
Element tube stretched ........................Replace
15
TROUBLESHOOTING