Champion d-h1t ユーザーガイド

Refer to Fig. 11.
There are two fuse blocks. A 3-pole block
(A) is located in the main control cabinet. 
The (A) fuses protect the wash tank heater 
circuit. Booster heater circuits (D-HBT only) 
are not fused. A 2-polefuse block is located 
on the machine base to protect the control circuit.

To Replace a fuse:
Turn the dishwasher main power switch 
off. Disconnect power to the machine at 
the main service disconnect switch. 
Replace the fuse. If the fuse blows again, 
DO NOT INCREASE THE FUSE SIZE.
DETERMINE THE CAUSE OF THE OVERLOAD.

Motor Overloads —

The wash pump motor has an overload to protect it from 
line voltage electrical overloads. The overload disconnects
120VAC power to the motor contactor coil.

Refer to Fig. 12.

Note the Switch Lever on the Overload.
If the switch lever is off with the “0” showing
then the overload has tripped.

To Reset the Motor Overload:
Flip the overload switch to the On position.
A “1” should be visible on the switch lever.

To Replace a Motor Overload:
Disconnect the wires to the overload.
Release the mounting catch on the front 
side of the overload. Push forward and lift out.
Snap the new overload into place and reconnect 
the wires.

To adjust the overload setting:
The screwdriver in Fig. 12 is positioned 
to adjust the motor overload AMP setting.
Read the full load amps (FLA) motor amps on the motor
nameplate. Turn the setting to match the name plate.

BASIC SERVICE

Switch Lever