Champion uh-100b インストール手順

Electrical Connection

Installation Guide

Electrical Connection

Electrical Connection

NOTE:

The electrical connection must be performed by a qualified electrician in

accordance with local codes and the National Electrical Code.
WARNING:

For models UH100B, UH170B, and UH200B disconnect the main power at

the main disconnect switch. Tag and lockout the switch to indicate that work

is being done on the circuit.

1. Refer to the connection diagrams below for proper dishwasher power

connection at the dishwasher main terminal block (MTB).

2. (a) Electrical supply must be a

single phase 3-wire plus ground which includes a current carrying neutral.

(b) For a three phase the electrical supply must be a 4-wire plus ground which

includes a current carrying neutral.

3. The dishwasher MTB is located at the front right-side of dishwasher.
4. Remove the dishwasher's lower front access panel by removing the two truss head

screws.

5. Carefully bump the lower front access panel up as you pull forward. Be careful not

to damage the pressure gauge mounted on the left side of the panel (not supplied

on models UL100, UH-100, or UH100B).

6. Remove the main terminal block cover. The machine's electrical schematic is

located on the inside of the front panel. Check the min/max data on the schematic.

7. Loosen the two screws securing the MTB. Then, pull the MTB up and forward.

208-230

VAC

208-230

VAC

208-230

VAC

115 VAC

208-230

VAC

115VAC

For machines prior

to S/N 14326