Champion pp-3 ユーザーズマニュアル
C O N T R O L P A N E L S
Stop Button
A normal press of this key stops the current cycle if one is active. If the unit is currently in
the Hold Mode, pressing the Stop key will turn off the unit.
the Hold Mode, pressing the Stop key will turn off the unit.
If the unit is currently in the Off Mode, a 2-second long press of this key will activate the
Manual Drain function.
Manual Drain function.
If the unit is presently in Power-Up or OFF mode then a 20-second long press of this key
will cause the unit to go into factory Low-Level programming mode.
will cause the unit to go into factory Low-Level programming mode.
Language Buttons
The 3 language keys allow selection of the language used for the displayed messages. If a
specific language is selected, its corresponding LED is also lit. To return to English, simply
press the currently selected language key again. When English is selected, no language
LED’s are lit. Thus, there are 4 languages supported.
specific language is selected, its corresponding LED is also lit. To return to English, simply
press the currently selected language key again. When English is selected, no language
LED’s are lit. Thus, there are 4 languages supported.
All internal messages are available in all languages.
Up/Down Buttons
These keys are used whenever adjustments of parameters are required in the various modes.
Whenever the unit expects either the Up or Down keys to be used, their corresponding
LED’s are lit.
Whenever the unit expects either the Up or Down keys to be used, their corresponding
LED’s are lit.
If the unit is in WASH or HOLD mode, using the UP and DOWN keys will adjust the
current Temperature. This will only change the Temperature until the next Power-Up state, at
which time the default factory programmed Temperature comes back into effect.
current Temperature. This will only change the Temperature until the next Power-Up state, at
which time the default factory programmed Temperature comes back into effect.
At any time, the Up/Down pair of keys can be pressed (at the same time) to display the
current heater sheath temperature. The 1
current heater sheath temperature. The 1
st
line of the display will scroll S H E A T H
T E M P E R A T U R E
and the 2
nd
line will display the current heater sheath temperature. After
5 seconds, the display reverts to whatever was previously displayed.
27