Champion pp-3 ユーザーズマニュアル

C O N T R O L   P A N E L S  
 

The cycle LED will light up and the first setting S T E P 1   D U R A T I O N  will scroll on the 
display, and alternate every 5 seconds with its value. 

Use the UP and DOWN  keys to adjust a setting.  Once the wanted value is displayed, 
pressing the OFF key again will bring up the next setting.  Change all settings for as many 
steps as required (up to 3 per Cycle).  If step duration is set to 0, then all following 
parameters are ignored and the unit returns to the previous mode.  It is assumed that 
programming for this particular cycle is finished. 

Note that in all setting descriptions below, X  can be 1 ,   2 , or 3 , depending on the current 
step being programmed. 

This is the time that the unit will remain in the current step.  If there is only 1 step defined 
for the cycle, this also corresponds to the total cycle time.  If a step has 0 duration, the 
current step and all following ones are not programmable (i.e. not used).  If step 1 is set to 0, 
then the cycle is not defined and pressing the Cycle key will not do anything. 

Setting name:   S T E P   X   D U R A T I O N  
Allowed values:   0 : 0 0  to 9 . 5 9  
Default value:   1 : 0 0  

The wash tank’s water temperature is defined here. 
 
Setting name:   S T E P   X   T E M P E R A T U R E  
Allowed values:  1 0 0 ˚ f   to 1 2 5 ˚ f     

(

3 8

˚ c  to 5 2 ˚ c

)

 

Default value:   1 1 5 ˚ f    

(

4 6

˚ c

) 

 

This is the pump speed during the particular step. 

Setting name:   S T E P   X   P U M P   S P E E D  
Allowed values: L O W ,   M E D ,   or  H I G H  
Default value:   L O W  

30