Champion usn-72 ユーザーガイド

In This Part—
•  Theory of operation
•  Description of operator controls
•  Start up procedure
•  Safety and operation checks
•  Shutdown procedure
•  Operation summary

Dishwashing requires five components to be effective: time, temperature, mechanical

action, chemical action and proper procedure.  Time allows everything to work.  Temperature

produced by the heat system is required to heat water in order to penetrate and loosen food soils.

Mechanical action produced by the pump system creates water pressure to flush food soils from

wares.  Chemical action in the form of detergents break down grease and dissolve food particles.

Proper procedures in the form of prescrapping, prerinsing, and proper loading maximize

dishwasher performance.

 The USN-72 series dishwasher consists of the wash tank and the power rinse tank. The power

rinse tank contains the final rinse piping.  Each tank is equipped with its own spray system and a

water holding tank.  Recirculating pumps draw water from the tanks and direct the water under

pressure through the spray system and onto the dishes.

Wash and power rinse water is heated in the tanks by a steam coil or electric tank heater.

The final rinse water for sanitizing is heated in an external steam or electric booster heater.

A rack conveyor system made up of dual chains and driven by a conveyor motor and gearbox

moves dishracks loaded with wares through the tanks.  The wash tank water, which is heated to a

minimum of 150

°

F., contains detergents.  Wares are conveyed to the wash tank where they are

sprayed with the detergent solution.  Food particles and other soils are flushed from the wares and

are collected in scrap screens above the water holding tank.  Wares continue on the conveyor

system to the power rinse tank which is heated to a minimum of 160

°

F.  The power rinse tank

spray system rinses remaining soils and soapy water from the wares.

The final stage of the washing operation occurs in the final rinse section.  Upper and lower final

rinse spray pipes are located at the exit end of the dishwasher.  As the dishrack containing wares

approaches the final rinse area, the dishrack operates a final rinse switch.  The switch activates

the final rinse system.  Final rinse water, heated to a minimum of 180

°

F., is forced by water line

pressure from the final rinse booster heater.  Water sprays from the upper and lower final rinse

piping on the wares to sanitize them.  The wares are conveyed out the exit end of the dishwasher

where operators remove and stack the wares for the next meal period.

The USN-72 is equipped with several safety features.  Door safety switches prevent the unit

from running if a door is open.  A conveyor limit switch stops the dishwasher operation if the

conveyor becomes jammed.  A float switch located in each tank stops the unit if the water level

falls below a preset level.  Finally, a low temperature sensor stops machine operation if the final

rinse water falls below 180

°

F.

Part 3: OPERATION