Champion usn-72 ユーザーガイド

0

1

2

3

UP

4

5

6

Omron

H2C

 

1

2

3

4

5

6

7

8

Part 5: BASIC SERVICE

There are adjustable cycle timers located in the dishwasher control cabinet.  They are

designated WT and RT on the electrical schematic.  The timers are 8 pin plug in modules

with two (3) user defined settings.

To set a timer:  Hold the replacement timer with the timer dial facing up.  Locate the

setting in the upper right corner of the timer. Turn the adjust screw  to 60 S for  (60

seconds).   Flip the timer over to view the back and make sure the setting in the lower

left corner is set to 60 for 60 Hertz.  Finally, turn the timer over to view the timer dial

again and set the timer dial to 5 for five seconds.

There are two pilot lights  on the front of the dishwasher control

cabinet. One indicates Power On;  the other indicates either Low

Booster Temperature, or Reset Required. If the dishwasher is

equipped with a final rinse chemical sanitizing system then the

pilot light indicates Reset Required.

To replace an indicator bulb: Turn off the power at main service

disconnect switch.  Open the control cabinet cover and locate the

desired pilot light assembly.  Push the pilot light locking tab 1/4

turn in a clockwise direction as viewed from the front to release the

light assembly from its mounting socket.  Remove the bulb by

turning it gently 1/2 turn in either direction.  Install a replacement

bulb and reassemble in reverse order.  Return the dishwasher to

normal operation.