Net Media nm-utpball 仕様ガイド

MAN-UTPBALL     REV0703A

NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona  85737 (520) 544-4567 Fax: (520) 544-0800 Email: sales@netmedia.com www.netmedia.com

Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a 

loopback or video output jack.

Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on 

the modulated channel. The modulator can also be the last piece of equipment in Figure 2.

Installation Procedures:

1. Connect a UTP cable (CAT5 or better) to the UTP jacks of the camera and Video Decoder. Each camera/decoder pair 

needs a dedicated point-to-point wiring circuit. If attaching your own plugs, wire them for straight-through connec-
tions: pin1 to pin1, pin2 to pin2; pin3 to pin3, etc. For standardization, you should also follow the T-568A color specifi-
cation but it will not affect the camera’s function. Do not connect the UTP cable to computer networks or other 
UTP video systems! Doing so could damage this product and/or the other attached devices!

2. Connect a video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the Decoder’s RCA Video Out 

jack. Simple adapters, such as RCA to BNC, may be used where appropriate.

3. Connect the 24V DC 200mA Power Transformer from an AC outlet to the Decoder’s Power Input Connector.
4. Mount the camera base to the junction box (not included) and adjust the camera assembly for proper viewing. When 

satisfied, secure all adjustment points.

Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV’s composite RCA Video In 

jack and view through its video or line input. The picture will not be available on a channel.

Distribution 

Panel

 or Splitter

Splitter/

Combiner