Sony DCR-PC350 ユーザーガイド
Dubbing/Editing
104
10
Touch [MARK OUT].
The ending point of the first program is set,
and the lower part of the program mark
changes to light blue.
and the lower part of the program mark
changes to light blue.
11
Repeat steps 7 to 10 and create
programs.
programs.
12
Set your VCR to recording pause.
Skip this step if your camcorder is
connected via an i.LINK cable or recording
on a “Memory Stick Duo.”
connected via an i.LINK cable or recording
on a “Memory Stick Duo.”
13
Touch [START].
14
Touch [EXEC].
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during the search and
[EDITING] appears during editing.
program starts, then the recording starts.
[SEARCH] appears during the search and
[EDITING] appears during editing.
When a program is recorded, the program
mark changes from orange to light blue.
When all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, touch [CANCEL].
mark changes from orange to light blue.
When all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, touch [CANCEL].
To end Digital program editing
Touch [END].
To save a program without using it to
record
record
Touch [END] in step 11.
The program is stored in memory until the
cassette is ejected.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 6 in “Recording the
selected scenes as programs” (p. 103),
then touch [UNDO].
selected scenes as programs” (p. 103),
then touch [UNDO].
2
Touch [DEL 1MARK] to delete the last
set program. Or, touch [ALL ERASE] to
erase all the programs.
set program. Or, touch [ALL ERASE] to
erase all the programs.
3
Touch
[EXEC]
.
The programs are deleted.
To cancel this operation, touch [CANCEL].
To cancel this operation, touch [CANCEL].
b
Note
• You cannot set starting point or ending point on a
blank section of the tape. If there is a blank section
in the picture set as a program, the total time may not
appear correctly.
in the picture set as a program, the total time may not
appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 11 on
page 99, and set the [IR SETUP] code.
page 99, and set the [IR SETUP] code.
PROG. EDIT
0:00:00:00
START
UNDO
MARK
IN
EDIT
SET
END
TOTAL
SCENE
SCENE
0:00:00:12
1
1
START
0:00:00:00
CANCEL
EXEC
ENGAGE
REC PAUSE
TOTAL
SCENE
SCENE
0:00:00:25
3
3
SEARCH
0:00:00:00
–x1
END
SCENE 1/3
CANCEL