Roland DP-900 インストール手順
4.
Raise the entire assembly.
When standing the assembled unit up, grasp near the
speaker box and center part of the DP-900, and gently
raise the assembly.
speaker box and center part of the DP-900, and gently
raise the assembly.
fig.st4
5.
Put the Pedal Board on the stabilizer.
When putting the Pedal Board on the stabilizer, first
loosen the screws securing the speaker box to the side
boards.
loosen the screws securing the speaker box to the side
boards.
fig.st5.e
6.
Secure the Pedal Board to the side boards with
the attachment screws (in two places).
Retighten the screws loosened in Step 5.
fig.st6.e
To stabilize the pedals
Temporarily loosen the screws that fasten the pedal board.
Step on the pedal, and after verifying that the pedal is in firm
contact with the floor, re-tighten the screws firmly.
contact with the floor, re-tighten the screws firmly.
7.
Lay the DP-900's keyboard onto the stand and
secure it with the screws (in four places).
Place the keyboard so that it is centered, both front to
back and left to right.
back and left to right.
* Take care not to allow your hands to becomme caught when
holding the keyboard.
fig.st7.e
8.
Connect the speaker cable extending from the
rear of the speaker box to the DP-900’s speaker
connector.
Press the speaker cable completely into the connector so
that it is securely fastened.
that it is securely fastened.
fig.st8.e
9.
Connect the pedal cables to the Pedal [Damper]
jack and [Soft] jack.
Connect the brown plug to the Damper jack, and the
black plug to the Soft jack.
black plug to the Soft jack.
10.
As necessary, affix cord clamps as shown in
the diagram to fasten the pedal cable.
fig.st9.e
When Moving the Instrument
Disconnect the AC cord and cables from the DP-900.
Then lift the piano while keeping it level, and move it with
care, so that you do not drop it on your feet, or get your
hands caught.
care, so that you do not drop it on your feet, or get your
hands caught.
Check the stability of the pedal, and make adjustments as
necessary.
necessary.
When Disassembling
Disassemble the unit by carrying out assembly Steps 1-10 in
reverse order.
reverse order.
When Changing the Orientation of the
Speaker Box
Speaker Box
Be sure to completely disassemble the unit, change the
speaker box orientation, then reassemble it.
speaker box orientation, then reassemble it.
Loosen the screws
(in four places).
Pedal Board
Attachment
screws
screws
Attachment
screws
screws
DP-900 Rear
Clip Portion
Hold and insert the cable so that
the clip portion extends into the
stand and is securely connected.
Speaker Connecter
Speaker cable
Cord Clamps
Pedal Cord
40563878 1PD
Intro_e.fm 11 ページ ２００４年６月３日 木曜日 午後４時４８分