Enterasys ssr-atm29-02 ユーザーガイド
Chapter 5: Changing System Settings
56
CoreWatch Users Guide
8.
Set the Layer 2 hash mode for the port. The hash mode controls the distribution of
flow entries in Layer-2 and Layer-3 lookup tables. Assuming a MAC address of the
value 0011:2233:4455, the following list describes the various hash modes:
flow entries in Layer-2 and Layer-3 lookup tables. Assuming a MAC address of the
value 0011:2233:4455, the following list describes the various hash modes:
–
M0 – 0011:2233:4455
–
M1 – 0011:2233:5544
–
M2 – 0011:3322:4455 (default hash mode)
–
M3 – 1100:2233:4455
Note: Cabletron has configured the SSR’s hash mode to its optimal setting. It is
recommended you not change the hash mode unless advised to do so by
Cabletron Technical Support.
Cabletron Technical Support.
9.
Click OK.
Configuring the SSR for a SYSLOG Server
You can configure the SSR to send system messages to a SYSLOG server. To do so, identify
the server the SSR is to send messages to and also specify the type of messages that the
SSR is to send. On the SYSLOG server, you can decide whether to discard the messages,
write them to a file, or send them out to the console.
the server the SSR is to send messages to and also specify the type of messages that the
SSR is to send. On the SYSLOG server, you can decide whether to discard the messages,
write them to a file, or send them out to the console.
To configure the SSR for a SYSLOG server:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
System Configuration object.
System Configuration object.
3.
Select the System Log object.