Marantz dv4500 ユーザーガイド

ページ / 28
– 2 –
EN
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE 
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. 
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol within an 
equilateral triangle is intended to alert the user to the 
presence of uninsulated “dangerous  voltage”  within  the 
product’s  enclosure that may be of sufficient magnitude 
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is 
intended to alert the user to the presence  of  important
operating  and  maintenance (servicing) instructions in the
literature accompanying the product.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO 
WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA 
PLUS LARGE DE LA FICHE  DANS LA BORNE CORRESPONDANTE DE LA 
PRISE ET POUSSER JUSQU’AU FOND.
NOTE:
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions,may 
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by tuning 
the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
NOTE:
Changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to 
operate the equipment.
This product is for general household purposes. Any failure 
due to use for other than household purposes (such as long 
- term use for business purposes in a restaurant or use in a 
car or ship) and whichrequires repair will be changed for even 
during the warranty period.
LASER SAFETY
This unit employs a laser. Only a qualified service person 
should remove the cover or attempt to service this device, 
due to possible eye injury.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR  
PERFORMANCE OF PROCEDURES OTHER THAN THOSE 
SPECIFIED HERE MAY RESULT IN HAZARDOUS RADIATION 
EXPOSURE.
CAUTION VISIBLE AND INVISIBLE LASER RADIATION WHEN
OPEN AVOID EXPOSURE TO BEAM (WARNING
LOCATION: INSIDE ON LASER COVERSHIELD)
Information to User
Alteration or modifications carried out without appropriate authorization 
may invalidate the user's right to operate the equipment.
Do not remove the cover from the equipment.
Do not insert anything into the equipment through the ventilation  holes.
Do not handle the mains lead with wet hands.
Make a space of about 0.1 meter around the unit.
IMPORANT NOTICE
[For U.S. model]
The serial number for this equipment is located on the rear panel. 
Please write this serial number on your enclosed warranty card and
keep it in a secure area. This is for your security.
CAUTION:
This product satisfies FCC regulations when shielded cables and 
connectors are used to connect the unit to other equipment.
To prevent electromagnetic interference with electric appliances
such as radios and televisions, use shielded cables and connectors
for connections.
 Operating Environment
Operating environment temperature and humidity:
 • Location exposed to direct sunlight or strong artificial light
 • Location exposed to high humidity, or poorly ventilated location
+5 C to +35 C (+41 F to +95 F); less than 85%RH (cooling vents not
blocked) Do not install in the following locations 
E59M0UD.qx3  04.6.24  2:34 PM  Page 2