Marantz ud9004 ユーザーガイド

7

ENGLISH

e

  Put the rear cover back on.

q

  Remove  the  remote  control 

unit’s rear cover.

w

  Set three AAA/R03 batteries in 

the battery compartment in the 
indicated direction.

Use AAA/R03 batteries in this remote control. 

• 

Replace  the  batteries  with  new  ones  if  the  set  does  not  operate 

• 

even  when  the  remote  control  unit  is  operated  close  to  the  unit. 
(The supplied batteries are only for verifying operation.)
When inserting the batteries, be sure to do so in the proper direction, 

• 

following the “q” and “w” marks in the battery compartment.
To prevent damage or leakage of battery fluid:  

• 

Do not use a new battery together with an old one.
Do not use two different types of batteries.
Do not attempt to charge dry batteries.
Do not short-circuit, disassemble, heat or dispose of batteries in 
flames.

If the battery fluid should leak, carefully wipe the fluid off the inside 

• 

of the battery compartment and insert new batteries.
Remove the batteries from the remote control unit if it will not be in 

• 

use for long periods.
Used batteries should be disposed of in accordance with the local 

• 

regulations regarding battery disposal. 

Point the remote control unit at the remote sensor when operating 
it.

The set may function improperly or the remote control unit may not 
operate  if  the  remote  control  sensor  is  exposed  to  direct  sunlight, 
strong artificial light from an inverter type fluorescent lamp or infrared 
light.

MARANTZ BD players in the vicinity.  
Set the remote control code simultaneously on the main unit, too. 
For  how  to  set  codes,  see  GUI  menu:  “Other  Setup”  –  “Remote 
Control Setting” – “Remote ID” (vpage 32).

G

Remote control code settingH

The supplied remote control has two remote control code settings: 

• 

BD 1 and BD 2.
The code is set to “BD 1” at the factory.

• 

To set the code to “BD 2”, hold the 

• 

 (2) button and the Number 

button [2] pressed for more than five seconds.
To set (return) the code to “BD 1”, hold the 

• 

 (2) button and the 

 button [1] pressed for more than five seconds.

If the signal code of the remote control does not match the signal 

• 

code of the unit, the remote control code set on the unit is shown 
on the display. 
G

ExampleH

If  the  code  setting  on  the  unit  is  “BD  1”,  and  the  setting  on  the 
remote control is “BD 2”, “BD 1” is shown on the display. 

Match the signal code of the remote control with the signal code of 
the unit. If the remote control code is different, you cannot operate 
the UD9004 with the remote control.

q

e

w

Batteries

30°

30°

Approx. 5 m