Sceptre s6500 ユーザーガイド
Notebook User’s Guide
94
The AC Adapter and Peripherals Connection
The AC Adapter port and all peripheral ports are located on the rear side of the
I/O Replicator. Please see Figure 6-8 for a complete port layout. You will
want to place the I/O Port Replicator flat on a desk near a wall outlet or an
extension cord with a built-in circuit breaker.
I/O Replicator. Please see Figure 6-8 for a complete port layout. You will
want to place the I/O Port Replicator flat on a desk near a wall outlet or an
extension cord with a built-in circuit breaker.
Please see the I/O Port Replicator’s user manual for information on making
peripheral connections.
peripheral connections.
The Notebook to I/O Port Replicator Connection
By inserting your Notebook into the I/O Port Replicator, and by connecting
peripheral devices (a keyboard, mouse, monitor, printer, etc.) to the
Replicator’s rear side, the I/O Port Replicator turns your Notebook computer
into a fully functional desk-top PC. Your Notebook can be hot-plugged into
the I/O Port Replicator. This means that you do not have to turn off the
Notebook before connecting it to the I/O Port Replicator.
peripheral devices (a keyboard, mouse, monitor, printer, etc.) to the
Replicator’s rear side, the I/O Port Replicator turns your Notebook computer
into a fully functional desk-top PC. Your Notebook can be hot-plugged into
the I/O Port Replicator. This means that you do not have to turn off the
Notebook before connecting it to the I/O Port Replicator.
Even though you may be able to fit other Notebook
computers into the I/O Port Replicator, it is strongly
recommended you do not use it with any other
notebooks before checking with an authorized service
technician. This could result in severe electrical
damage to the Replicator and your Notebook.
computers into the I/O Port Replicator, it is strongly
recommended you do not use it with any other
notebooks before checking with an authorized service
technician. This could result in severe electrical
damage to the Replicator and your Notebook.
To connect your Notebook to the Port Replicator observe the following steps:
1. Prepare the Port Replicator by connecting the desired peripheral devices
and connecting the Port Replicator to an AC power source.
2. If no peripheral devices are connected to the Notebook, there is no need to
turn off the system since it can be hot-plugged into the Port Replicator.
However, it is recommended that you save your data and enter the system
into the suspend mode and close the LCD lid.
However, it is recommended that you save your data and enter the system
into the suspend mode and close the LCD lid.
3. Locate the two grooves on the bottom side of the Notebook. Place the
Notebook on the Port Replicator’s docking platform, aligning the grooves
with the Replicator’s docking rails (see Figure 6-9).
with the Replicator’s docking rails (see Figure 6-9).