Lenovo d20 4158 ハードウェアマニュアル
To set the ICH SATA Controller or Marvell SATA/SAS Controller, do the following:
1.
1.
Start the Setup Utility program (see “Starting the Setup Utility program” on
page 51).
page 51).
2.
Depending on which device you want to set, select either Devices → SAS/SATA
Drive Setup → ICH SATA Controller
Drive Setup → ICH SATA Controller
or Devices → SAS/SATA Drive Setup →
Marvell SATA/SAS Controller
from the Setup Utility program menu.
3.
Select the desired settings and press Enter.
4.
Return to the Setup Utility program menu and select Exit → Save and exit the
Setup Utility
Setup Utility
.
Note:
If you do not want to save the settings, select Exit the Setup Utility
without saving
without saving
.
To set the Legacy diskette A, do the following:
1.
1.
Start the Setup Utility program (see “Starting the Setup Utility program” on
page 51).
page 51).
2.
From the Setup Utility program menu, select Devices → Legacy diskette A.
3.
Select the desired settings and press Enter.
4.
Return to the Setup Utility program menu and select Exit → Save and exit the
Setup Utility
Setup Utility
.
Note:
If you do not want to save the settings, select Exit the Setup Utility
without saving
without saving
.
Selecting a startup device
If your computer does not start up (boot) from a device such as the disc, diskette,
or hard disk drive as expected, use one of the following procedures to select a
startup device.
or hard disk drive as expected, use one of the following procedures to select a
startup device.
Selecting a temporary startup device
Use this procedure to start up from any boot device.
Note:
Not all discs, hard disk drives, and diskettes are bootable.
1.
Turn off your computer.
2.
Press and hold the F12 key then turn on the computer. When the Startup
Device Menu appears, release the F12 key.
Device Menu appears, release the F12 key.
Note:
If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
3.
Select the desired startup device from the Startup Device Menu and press Enter
to begin.
to begin.
Note:
Selecting a startup device from the Startup Device Menu does not
permanently change the startup sequence.
permanently change the startup sequence.
Selecting or changing the startup device sequence
To view or permanently change the configured startup device sequence, do the
following:
1.
following:
1.
Start the Setup Utility program (see “Starting the Setup Utility program” on
page 51).
page 51).
Chapter 6. Using the Setup Utility
53